A Milnor down in a hospital or central laundry isn't an inconvenience — it's a linen schedule on fire. The factory-authorized route in Texas runs through a dealer's queue. We're the independent option, local to San Antonio and South Texas: washer-extractors, tunnel washers, and CBW systems, diagnosed and repaired without the dealer wait or the sales agenda.
Trusted by commercial accounts including Embassy Suites San Antonio
Milnor washer-extractors (rigid-mount and divided-cylinder), tunnel washers and CBW batch systems,
and Milnor dryers — Mark and MilTouch control generations — in hospitals, central and
healthcare laundries, hotels, correctional, and industrial plants.
A Tex Service Co. is an independent service company — not affiliated with, endorsed by,
or an authorized dealer of Pellerin Milnor Corporation. Brand names are used for identification only.
Milnor machines are the backbone of high-volume laundries — the washer-extractors and tunnel systems that hospitals, hotels, and central plants build their whole operation around. When one goes down, there's rarely spare capacity to absorb it, and in healthcare the linen schedule is a compliance issue, not a preference. A dealer dispatch on the factory's timeline can turn a one-day repair into a multi-day crisis. Local, independent, repair-first service is the difference between a service call and a shutdown — and preventative maintenance on bearings, seals, and drives is how the best operations never find out.
Washer-extractor, tunnel, or dryer; Mark or MilTouch control; and the fault or symptom. On industrial Milnor equipment, the code and model narrow the diagnosis fast.
Drive/VFD, motor, interlock circuit, bearings, seals, sensors — we trace the actual cause instead of swapping the most expensive part first. Common interlock, drive, and seal components travel with us.
Full cycle including extract before we leave, so the machine holds. PM contracts available to keep bearings, seals, and drives ahead of failure on equipment that can't afford surprise downtime.
Yes. Milnor's higher-capacity washer-extractors run on inverter/VFD drives, and a drive fault can come from the drive itself, the motor, the door interlock circuit that gates the spin, or a sensor feeding the control. We diagnose the drive chain end to end rather than swapping the most expensive part first. Tell us the Mark or MilTouch code when you call (210) 870-9157 and we can prep the likely parts.
You do. The factory-authorized Milnor channel in Texas is a dealer whose dispatch and priorities run through their own queue. We're an independent repair company local to San Antonio and South Texas, so you get faster response on a down machine and a repair-first answer, and we service your Milnor regardless of where it was purchased or who installed it.
Milnor washer-extractors (rigid-mount and divided-cylinder models), tunnel washers and CBW batch systems, and Milnor dryers, across Mark control and MilTouch control generations. These run in hospitals, central and healthcare laundries, hotels, correctional facilities, and industrial/uniform plants — the high-volume operations Milnor is built for.
That's the profile we're built for. When a Milnor in a healthcare or central laundry goes down, linen schedules don't pause. We prioritize these calls, carry common interlock, drive, bearing, and seal components, and offer preventative maintenance contracts that catch bearing and seal wear before they take the machine — and the linen line — out of service.
No — we're an independent commercial and industrial laundry repair company, not affiliated with or endorsed by Pellerin Milnor Corporation. For repair, that independence means faster local response than a dealer dispatch and no sales-tied agenda. We source Milnor parts and repair on the machine's merits.
Fill this out in under 2 minutes and we'll call within 1 business hour. If a machine is down right now, calling is faster.
We'll call you within 1 business hour. If it's urgent, dial (210) 870-9157 right now.